Home   Runcards   Admin
Brought to you by the Utah Nanofab

Deposition | Sputter | Denton 635 | Cr (4 in)

User Inputs

Name Value Unit
Film Thickness nm
Power Watts

Process Parameters

Name Value Unit
Base Pressure 2.0E-6 Torr
Commercial Rate 160 $/Hr
Gas Flow (Ar) 35 sccm
Gas Flow (N2) 0 sccm
Gas Flow (O2) 0 sccm
Gas Pressure (VAT Controlled Yes) 5 mTorr
Power Type 1 DC
Pre-Sputter Time 1 minutes
Pump Down Time 40 minute(s)
Sputter Rate 4.5 nm/min

Predicted Results

Name Value Unit Confidence Data Origin
Bulk Resistivity 141.53 micro ohm cm 0
Film Resistivity 51.435 micro ohm cm 0
Latest Depth Measurement 0.104 inches 98 Total thickness = 0.250" Measured on 09/23/2026

Notes

Note Date Modified Author
Cr (4 In) is usually installed in C2 2025-11-12 22:00:23 anonymous
The sputter rate is at 50W of power. A ratio is used when changing the power to give the expected deposition time. 2025-01-24 16:00:52 anonymous
  Add to Run Card