| Name | Value | Unit |
|---|---|---|
| Film Thickness | nm | |
| Power | Watts |
| Name | Value | Unit |
|---|---|---|
| Base Pressure | 2.0E-6 | Torr |
| Commercial Rate | 160 | $/Hr |
| Gas Flow (Ar) | 35 | sccm |
| Gas Flow (N2) | 0 | sccm |
| Gas Flow (O2) | 0 | sccm |
| Gas Pressure (VAT Controlled Yes) | 5 | mTorr |
| Power Type | 1 | DC |
| Pre-Sputter Time | 1 | minutes |
| Pump Down Time | 40 | minute(s) |
| Sputter Rate | 2.5 | nm/min |
| Name | Value | Unit | Confidence | Data Origin |
|---|---|---|---|---|
| Bulk Resistivity | 42 | micro ohm cm | 0 | from old process page |
| Film Resistivity | 78.4 | micro ohm cm | 0 | |
| Latest Depth Measurement | 0.150 | inches | 98 | Total Ti thickness = 0.250 Measured 09/23/2026 |
| Note | Date Modified | Author |
|---|---|---|
| Ti (3 In) is usually installed in C4 | 2025-11-17 17:37:22 | anonymous |
| The sputter rate is at 50W of power. A ratio is used when changing the power to give the expected deposition time. | 2025-01-24 16:00:52 | anonymous |