Home   Runcards   Admin
Brought to you by the Utah Nanofab

Deposition | Sputter | Denton 635 | SiO2 (3 in)

User Inputs

Name Value Unit
Film Thickness nm
Power Watts

Process Parameters

Name Value Unit
Base Pressure 2.0E-6 Torr
Commercial Rate 160 $/Hr
Gas Flow (Ar) 35 sccm
Gas Flow (N2) 0 sccm
Gas Flow (O2) 0 sccm
Gas Pressure (VAT Controlled Yes) 5 mTorr
Power Type 1 RF
Pre-Sputter Time 1 minutes
Pump Down Time 40 minute(s)
Sputter Rate 0.45 nm/min

Predicted Results

Name Value Unit Confidence Data Origin
Bulk Resistivity 0 micro ohm cm 0 from old process page
Film Resistivity 0 micro ohm cm 0

Notes

Note Date Modified Author
SiO2 (3 In) is usually installed in C3 2026-07-22 15:15:15 anonymous
The sputter rate is at 50W of power. A ratio is used when changing the power to give the expected deposition time. 2025-01-24 16:00:52 anonymous
  Add to Run Card